RAYTAC MDBT42Q-ATM, Manual

Page: 6 / 62

5
2.2. AT Command Sets
2.2.1.
“Write” Commands
No. Command Description
(1) AT+NAME
Set scanned device name. Max. length of 20 characters
e.g. AT+NAME123 (device name 123, 3 characters)
(2) AT+RESET Set to reset system
(3) AT+SCANOLDSTART Set to start scanning paired device
(4) AT+SCANNEWSTART Set to start scanning ALL devices
(5) AT+SCANSTOP Set to stop scanning
(6) AT+SLEEP Set to get into deep sleep mode
(7) AT+BAUDRATE9600 Set UART baud rate at 9600 bps,n,8,1
(8) AT+BAUDRATE19200 Set UART baud rate at 19200 bps,n,8,1
(9) AT+BAUDRATE38400 Set UART baud rate at 38400 bps,n,8,1
(10) AT+BAUDRATE57600 Set UART baud rate at 57600 bps,n,8,1
(11) AT+BAUDRATE115200 Set UART baud rate at 115200 bps,n,8,1
(12) AT+BAUDRATE230400
Set UART baud rate at 230400 bps,n,8,1
(recommended enabling flow control)
(13) AT+BAUDRATE460800
Set UART baud rate at 460800 bps,n,8,1
(recommended enabling flow control)
(14) AT+FLOWCONTROLDIS Disable UART flow control
(15) AT+FLOWCONTROLEN Enable UART flow control
(16) AT+TXPOWER4DBM Set RF TX power at + 4dBm
(17) AT+TXPOWER0DBM Set RF TX power at 0dBm
(18) AT+TXPOWER-4DBM Set RF TX power at - 4dBm
(19) AT+TXPOWER-8DBM Set RF TX power at - 8dBm
(20) AT+TXPOWER-20DBM Set RF TX power to - 20dBm
(21) AT+XTALINTERNAL Use internal RC 32.768KHZ low frequency oscillator
(22) AT+XTALEXTERNAL Use external crystal 32.768KHZ low frequency oscillator
(23) AT+CONNECTINDICATORLOW Set logic low output when connecting BT
(24) AT+CONNECTINDICATORHIGH Set logic high output when connecting BT