4.1.3 Switching the Device On and Off
Page 13
4.1.3 Switching the Device On and Off
On the rear wall of the Rayocomp
PS 10, you will find the switch for
switching the device on and off.
When switching on, please make
sure that no memory card is
inserted in the device. In case your
PS 10 is not under supervision for a
longer period of time (overnight,
for example), make sure that the power pack is charged sufficiently.
Total
discharge, even if it happens only once, damages the power pack
permanently.
After the device is switched on, a short trial run is started. A mechanical test
is performed, along with a check of the power pack. If you receive the
message “Er 29”, the power pack must be recharged before you can work
with the device.
Then the device switches over to the menu item “Direct” and
is immediately ready for action. The display shows:
It is not necessary to move to a certain menu item before switching off the
device. This means you can switch off the device at any time. Please keep in
mind that the resonance values and the found RAH programmes detected in
the menu item “Test” are lost when the device is switched off. When the
status of the power pack goes down until its functions can no longer be
guaranteed, a ‘blip’ can be heard several times.
In this case, the power pack
must be recharged immediately to avoid damage.
Important information:
You cannot damage your device by switching it off arbitrarily. Neither
will the integrated harmonising programs be lost nor will your hardware
suffer damage.
