Chapter 4: Lubrication and Maintenance
34 |
P a g e
DOC-S0508-1R14-IMEI02 • Technical Manual • Issue
side guide and 6” piece at top
Inspect for any damage on guide
assemblies
Remove any excess old grease
Head Unit
Head Unit
Inspect drums for damage
Inspect upper and lower methylene
pieces for excessive wear
Remove old excess grease from
drive sprockets(gears)
Make shaft safety brackets are in
place and free of damage.
Repair as needed
Motor
Verify safety cable is present and
damage free
Verify that the motor mounting
bumpers are tight against the head
unit and are free of damage
Make sure Motor Fan is present
and working properly
Verify there are no leaks present
on reduction
Verify keyway for manual operation
is free from damage
Repair as needed
Cables
Verify cables are in good condition
and not spliced
Repair as needed
Counter
weight
Inspect strap for fraying and/or
cuts
Inspect nylon pulley for wear
Verify that counter weight travel is
not obstructed
Verify that pulley support is not
bent or shifted to the side
Verify the correct dimension of
shaft and strap at the open position
Repair as needed, refer to the
counterweight section of this
manual.
For an example of an inspection check list please see the back of this manual along with the
maintenance log.
