Rayming RMLASER, Manual

Page: 41 / 42

Question Reason Solut10n
Machine
Laser power is bad change laser power
doesn
’
t produce
Laser power data wire is bad change laser power data wire
laser
There is no TTL signal output in control Check control si g nal
古1e laser tube is aging change las er tube
乱fachine can
’
t
The focus lens is dirty Clean the focus l
巳
ns
cut completely
The refl
巳
ction lens is dirty Clean the reflection lens
The light is not right.
'
Adjust the light.
There are two
I
The light is not in the middle of the focus len s ,
cuts. I may be sent onto the metal and then refle cte d.
Adjust the third reflection lens
口口
＋EM
n
n
l
wu
m飞回归
U
缸
η
兀、
c
u
ω
k
n
吨
C
K
G
E
e－－
’且
e
’
b
－
W出
问
古1e X, Y guide is not uprig ht. Adjust the X, Y guide to upright.
Remove trouble
1. Laser tube doesn't give out light during testing.
How to check:
Is water pump been opened? There shall be water flowing out of outlet.
Whe吐1er laser power supply and l as e r tube are damaged?
2. Laser s canning mechanism doesn't work when power switch has been on.
Check:
Whether the contr o l panel supply power? Whether the USE connection of laser
machine and computer has trouble
乡
or whether the composition of laser engraving
softw ar e has faults?
3. There is misplacing and scratching during working.
- 41 -