Rayming RMLASER, Manual

Page: 38 / 42

part of water and add cold water).
3, Special needs, when adjusting the lighting, pls don
’
t make it exceed 20MA to
prevent fast aging of laser tube.
4, Must clean the water case, water pump and rubber pipe eve町three days.
5, Must clean the lens before turning on the machine to start work. σl s notice it is not
when you are off duty)
6, Reflection lens should be cleaned carefully, otherwise you need to adjust light
agam.
7
步
When you clean the third reflection lens and focus lens, you should unpick them
firstly. After finish cleaning the lens, pls fix them firmly, but not too tight to make the
lens broken.
8, Pls pay attention to the focus each time before sta rting to work, if the focus is not
exact, it will badly i nfluence the engraving effe c ts.
9, Operator should s imply clean the working table each time finish working, pls do
not make the dust fly.
10, Operato r should clean the machine when finish working. And it must be done
w hen the power is off, y o u can push the guidewayy and cart slowly, prohibiting with
too large force.
11, Every week, operator should clean the guideway and add lubricant to the moving
gui d e .
12
乡
Every week
乡
operator should clean the outside installation ( fan, air pump and so
＼、，／
、
A ··A
- 38 -