Rayming RMLASER, Manual

Page: 10 / 42

4.1.1 Working environment
N o t e : Only qualified or trained person is authorized to install and repair
the equipment!
1) Machine must be put in the dry environment. It will cause abnormal
when operation if wet which include short circuit of component, part of
high-woltage discharge abnormally etc. moreover, the moisture
environment will cause some metal part s rusted.
2) Machine must be put in the less-dust room. Too much dust will pollute
the optic parts (lens and miηors) and shorten the lifet i me, and speed up
the abrasion of the mechanical parts.
3 ) Working con di tion
Surrounding temperatu re 10 - 30 ° C relative humidity <70%
Power suppl y single phase: 100-120V / 200-240V 50Hz l.6K矶F
The machine should be earthed well and the earthing resistance should be
less than 4.0 .
4.1.2 Unpack of the plywood box
Open the plywood box to get out the accessories and check them
according to the accessory list. Remove the plastic wrap covered the
machine.
10