Rayming RMLASER, Manual

Page: 13 / 42

4 .1 . 7 Installation of the laser tube
Take off the screw from the two mounts which are used for fitting the
laser tube.
Put the laser tube on two bases.
Attention: distinguish Light outlet and water inlet & outlet.
Plug in water inlet and outlet.
Connect with the anode and cathode of the la ser power respectively.
Open the power supply of the machine, then the water pump starts to
work. Check out whether there is any bubble of the laser tube after one
minute. Revolve the lo cation of the laser tube to squeez e out the bubbles.
Attention : Water inlet of the laser tube should be in the lower place,
and water outlet be in the higher, so there won't be any bubble.
Insert the power line of the laser power supply into control box.
4 .1. 9 Detections
Tun1 on the power supply of the main engine,
1)
If
the X, Y didn
’
t in the original place, it will back to origin.
2)
If
the X, Y stay in original place, and you can not move laser head in
every direction by hand, it indicates that the drive system of the machine
is NORMAL.
13