Raymarine VCM100, Installation Instructions Manual

Page: 36 / 58

D10491-2
Drill 11 mm
diameter hole
(4 positions)
Centre of Rotation
FORWARD
Cable Entry
140 mm
70 mm
150 mm
57 mm
Maximum
outline of
pedestal
IMPORTANT
Secure pedestal
before opening lid
Digital Pedestal
Mounting Template
3. Using a 3 mm drill bit, drill the 4 holes, as indicated on the
mounting template.
Check that the holes have been drilled in the correct position.
4. Using an 11 mm drill bit, drill through the 4 holes.
5. Remove the mounting template.
6. Ensure the lifting eyes are fitted to the pedestal. To fit a lifting
eye, remove the securing bolt, place the lifting eye in position,
and then secure the lifting eye with the bolt, to 7 Nm (5.2 lb ft)
torque.
7. The pedestal unit has a cap fitted over the open array mounting
shaft to protect the protruding coaxial pin. This cap must be left
in place until the open array antenna is fitted to the pedestal.
8. Grease the 4 metal studs with the supplied Denso paste.
D11781-1
18 mm
9. Insert the studs no more than 18 mm into the holes in the
pedestal base, and hand-tighten. 4 spare nuts are provided
36
HD and SuperHD Digital Open Array Installation instructions