Raymarine ST60 Tridata, Commissioning Manual

Page: 5 / 24

iii
• If a suppression ferrite is attached to a cable, this ferrite should not be
removed. If the ferrite needs to be removed during installation it must be
reassembled in the same position.
Suppression Ferrites
The following illustration shows typical cable suppression ferrites used with
Raymarine equipment. Always use the ferrites supplied by Raymarine.
Connections to Other Equipment
If your Raymarine equipment is to be connected to other equipment using a
cable not supplied by Raymarine, a suppression ferrite MUST always be
attached to the cable near the Raymarine unit.
Product information
To the best of our knowledge, the information in this book and other product
documentation was correct when printed. However, our policy of continuous
product improvement and updating may change product specifications
without notice, so unavoidable differences may occur between the product
and the information supplied with it.
Raymarine cannot accept liability for inaccuracies or omissions in any
product documentation.
D3548-2
81228_1.book Page iii Wednesday, November 19, 2003 10:29 AM