Raymarine ST60 Tridata, Commissioning Manual

Page: 21 / 24

Chapter 2: Preparation for Use 13
Leaving Dealer calibration
Hold down the and buttons for 2 seconds to save your settings and exit
Dealer calibration.
2.3 Checking operation
When installation and initial set up are complete, check that the ST60
Graphic Display performs satisfactorily by carrying out basic checks and
NMEA checks, before operational use.
Basic checks
Ensure that the display shows the appropriate chapters and pages, as
described in the
ST60 Graphic Display Operation Guide . When doing this,
be aware that some data types may not be supported by your system and
therefore will not be displayed on your ST60 Graphic Display. If you think
that data is missing, ensure that your system supports this data before
assuming that a fault exists.
NMEA checks
Ensure that the display operates satisfactorily with any NMEA equipment to
which it is connected.
81228_1.book Page 13 Wednesday, November 19, 2003 10:29 AM