Raymarine ST60 Tridata, Commissioning Manual

Page: 17 / 24

Chapter 2: Preparation for Use 9
• Set the instrument time to local time.
• Select the units in which temperature, speed, trip, depth and wind speed
from NMEA, are displayed.
• Select the function of the display
NMEA OUT
connector. This is either
• A remote alarm output for the Auxiliary Alarm (NMEA OFF),
or
•
NMEA output signals.
• Enable/disable individual remote alarms.
• Enable/disable the pilot pop up display.
• Configure the instrument to display specific pages.
Dealer calibration
Summary
The Dealer calibration procedures enable you to set:
• Access to User calibration on/off.
• Response settings for speed, depth heading wind angle, wind speed,
VMG, course over ground and speed over ground.
• The correct battery voltage reading.
Dealer calibration also gives access to:
• A default reset screen. This enables you to re-apply the factory settings if
you want to reset the instrument to a known operating condition.
• A self-test entry screen.
Procedure
To carry out Dealer calibration:
1. hold down the and buttons together for approximately
12 seconds, to select the Dealer calibration entry page (see
Dealer cali-
bration diagram).
2. Press the
track
and
reset
buttons together, to start Dealer calibration.
3. Referring to the Dealer calibration diagram below, use the button to
cycle to each screen in turn, and set the appropriate values as described
below.
81228_1.book Page 9 Wednesday, November 19, 2003 10:29 AM