Raymarine ST5000+, Owner'S Handbook Manual

Page: 67 / 108

Chapter 5: Installation
55
6. Assemble the spring washers (9) to the four bolts (8)
7. Fit the clamp (10) around the spool valve cable connection.
8. Tighten the bolts (8) until the main support bracket is secure.
9. Assemble the shaft of the Sterndrive Actuator (1) to the pivot
assembly (5) pin – the flat should rest on top of the pivot assembly.
10. Fit the “R” clip (2) to the pivot assembly (5) pin to retain the
Sterndrive Actuator (1).
11. Lower the Sterndrive Actuator (1) into the main support bracket
(12). Make sure that the fixed and spring loaded pins locate in the
corresponding holes in the outer tube of the Sterndrive Actuator.
12. Make sure that the shaft of the Sterndrive Actuator is parallel with
the power steering ram.
13. Slowly turn the steering system from hard-over to hard-over.
14. Make sure the steering system operates correctly – the engine and
steering systems must be free from obstructions.
D3191-1
1
11 10 8 9 14
15 2 3 4 5 6 7
1 Sterndrive Actuator 2 'R' clip 3 Pin 4 Split pin 5 Pivot assembly 6 Pin 7 Split pin 8
Bolts 9 Spring washers 10 Clamp 11 Spool valve cable connection 12 Main support
bracket 13 Power steering ram 14 Twin-engine connecting bar 15 Tiller bar
132_4c05.p65 14/06/99, 10:34 55