Raymarine ST5000+, Owner'S Handbook Manual

Page: 52 / 108

40
ST5000 Plus Sterndrive & Hydraulic Autopilots Owner’s Handbook
Note: Adjacent control heads, or instruments, must have a 6 mm
(1/4 in) gap between them to allow sun covers to be fitted.
Surface mounting
To fit a surface mount control head:
1. Apply the surface mount template (supplied near the rear of this
handbook) to the selected bulkhead.
2. Mark the centres of the two fixing holes and the cable boss.
D3243-2
1 4 2 3
3. Drill two 4 mm (5/32 in) diameter holes for the fixing studs.
4. Use a 90 mm (3.5 in) diameter cutter to drill the hole for the cable
boss (1).
5. Peel off the protective sheet from the self-adhesive gasket (4) then
stick the gasket into position on the rear of the control head bezel.
6. Screw the fixing studs (2) into the display head.
7. Pass the cables (SeaTalk, power, compass etc.) through the
bulkhead and connect them to the appropriate terminals (see
relevant subsection for connection details).
8. Assemble the control head to the bulkhead.
9. Secure the control head with the thumb nuts (3) provided. Tighten
the thumb nuts BY HAND. Do NOT use a wrench.
132_4c05.p65 14/06/99, 10:34 40