Raymarine RSW-Wired, Installation Instructions Manual

Page: 29 / 74

8.2 Connections overview
The wind transducer connects to the SeaTalkng ® / NMEA 2000 network
using the supplied adaptor cable and gateway.
1. Wind transducer connection — The wind transducer connects to the
supplied mast cable.
2. Gateway connection — The wires on the end of the mast cable connect
to the matching colored terminals on the gateway.
3. Gateway DeviceNet connection — The DeviceNet connector can
connect to the supplied SeaTalkng ® to DeviceNet adaptor cable, or
directly to a DeviceNet spur connection.
4. SeaTalkng ® connection — The supplied SeaTalkng ® to DeviceNet
adaptor cable is used to connect the wind transducer system to the
SeaTalkng ® network.
8.3 Connecting cables
Follow the steps below to connect the cable(s) to your product.
1. Ensure that the vessel's power supply is switched off.
2. Ensure that the device being connected has been installed in accordance
with the installation instructions supplied with that device.
3. Ensuring correct orientation, push cable connectors fully onto the
corresponding connectors.
4. Engage any locking mechanism to ensure a secure connection (e.g.: turn
locking collars clockwise until tight, or in the locked position).
5. Ensure any bare ended wire connections are suitably insulated to prevent
shorting and corrosion due to water ingress.
Cables and connections — General information 29