Raymarine RL70C, Owner'S Handbook Manual

Page: 94 / 218

80 HSB Series LCD Display
5.2 Using Chart Cards
The chartplotter has a built-in world map; most areas are covered on a scale of
about 500 nm per inch on the screen (200 nm per cm), although some populated
areas have details down to 300 nm on the screen.
To use the chartplotter as a navigation aid, charts with detailed information for
the area you wish to navigate are required. The charts are available on C-MAP
NT electronic chart cards (C-Cards), each of which can store as many as 20
charts in an electronic format. A single C-MAP chart normally provides as
much information as is available in paper charts for that geographic area, and
can be displayed down to a range of 1/64 nm on the screen if the data is
available.
Two card slots are provided on the display unit. Chart data from both slots can
be downloaded.
The chart scale in use is indicated in the status bar - the number represents the
distance (in nautical miles) displayed from the top of the screen to the bottom of
the screen.
Note: You can remove and insert cards while a chart is displayed. The chart
information is retained on-screen until the chartplotter redraws the screen: for
example, when you pan outside the current area, or use the
RANGE
key to
change the chart scale.
Data on a chart card is also available to a repeater display, which can be used
independently of the master. When the master display is switched off chart data
is retained on the repeater screen until the chart is redrawn.
Inserting a Chart Card
➤
To insert a chart card:
1. Check that the card is a C-MAP NT C-Card with the required chart stored
on it.
2. Open the card cover, at the lower left of the display front panel.
3. Hold the card with the title label towards the left, as shown in the
illustration.
4. Gently push the card into one of the two slots. It will only go in if it is the
correct way round. Push the card in as far as it will go, then move it to the
right so that the top is under the retaining pegs. The card will be held in
place by the pegs.
5. Close the card cover so that is clicks shut, to prevent water entering the
display unit.
Using Chart Cards