Raymarine Ray 90, Installation And Operation Instruction Manual

Page: 40 / 192

1
Splash-proof dust cap with lanyard
2 Mounting plate fixings x 3
3 Mounting plate nut
4 Mounting plate
5 Mounting plate gasket
6 Extension cable
1. Check the selected location for the Mounting plate, a clear flat area is required.
2. Using a pencil, offer up the Mounting plate to the desired location and mark the location of the
screw holes and the center hole on the mounting panel.
3. Drill the mounting holes using a suitable size drill bit.
4. Drill the center hole using a 25 mm (1 in.) hole cutting saw.
5. Pull the connector end of the cable through the hole in the mounting surface.
6. Place the Mounting plate gasket over the end of the connector.
7. With the recessed side facing away from the mounting panel, place the Mounting plate over
the end of the connector.
8. Place the lanyard end of the Splash-proof dust cap over the connector, ensuring the lanyard sits
in the recess in the Mounting plate.
9. Place the Mounting plate nut over the connector and tighten clockwise using a 13/16 in. (21 mm)
socket wrench, being careful not to damage the plastic nut by overtightening.
10. Secure the Mounting plate to the mounting surface using the supplied screws.
11. Attach the Handset / Fistmic connector to the cable connector and rotate the locking collar
clockwise to secure.
12. Connect the opposite end of the cable to the required connector either on the Base station or to
another pass-through panel mounting plate connector.
40