Chapter 3: Getting Started
3-3
However, if your repeater display is a PLUS fishfinder, you must
tell the unit to be a repeater.
➤
To set the fishfinder display to be the sonar repeater:
1. Press the
MENU
key.
The Menu soft keys appear.
2. Press the
SONAR SET UP
soft key.
The Sonar Set Up menu appears.
3. Press the trackpad until the
SONAR HSB MODE
parameter is high-
lighted (selected).
4. Press the
REPEATER
soft key.
5. Press
ENTER
.
The display unit is now designated as the Repeater.
Full details on setting up your DSM250 and display are given in
Chapter 4
.
3.5 Selecting Sonar Mode
If properly connected to an
hsb
2
PLUS Radar, Chartplotter, or
Fishfinder display unit, you can begin viewing echo sounder data
by setting the display to Sonar mode.
Note:
Data, such as depth, speed, temperature, log, and trip are still
available even if Sonar mode is not selected.
➤
To set the mode, press the
DISPLAY
key to show the
DISPLAY
pop-up,
then press again to cycle through the modes available, shown in
Figure 3-1
.
MENU
SONAR
SET UP¬
DISPLAY
Summary of Contents for DSM250
