Raymarine DSM250, Owner'S Handbook Manual

Page: 23 / 122

Chapter 2: Installation 2-3
This will not damage the equipment, but may cause the loss of
some information and may change the operating mode.
• Raymarine specified cables are used. Cutting and rejoining these
cables can compromise EMC performance and must be avoided
unless doing so is detailed in the installation manual.
• If a suppression ferrite is attached to a cable, this ferrite should not
be removed. If the ferrite needs to be removed during installation
it must be reassembled in the same position.
Suppression Ferrites
The following illustration shows typical cable suppression ferrites
used with Raymarine equipment. Always use the ferrites supplied
by Raymarine.
Figure 2-2: Typical Suppression Ferrites
Connections to Other Equipment
If your Raymarine equipment is to be connected to other equip-
ment using a cable not supplied by Raymarine, a suppression fer-
rite must always be attached to the cable that is closest to the
Raymarine unit.
D3548-3