Wuhan Raycus Fiber Laser Technologies Co., Ltd.
User Guide of RFL-C20000TZ
5
Please double check if each listed content is inside the package; and contact Raycus as soon as
possible if there are any issues.
Take extra care when removing the unit from the package and make sure that the fiber optic cable
stays away from any possible collision and vibration. Please do NOT distort, bend or pull the output cable
when unpacking the device; and avoid any collision to the head of laser output.
CAUTION:
The fiber optic cable and output head are precise optic instrument, ANY
vibration or impact to the output head, and twist or excessive bend to the cable will
damage the instrument.
2.4. Operation Environment
The operation conditions are listed as the following table:
Table 1The Operation Environment Conditions for the Laser
Model
C20000TZ
Supply voltage (V)
Three-phase four-wire system AC 323V~AC 437V
、
50/60Hz (including PE)
Power supply capacity
(kVA)
＞
85
Water cooling flow
(L/min)
＞
167(TOP flow
＞
75
，
BOTTOM flow
＞
92)
Installation
Environment
Flat, no vibration nor impact
Ambient Temperature
10℃
～
40℃
Relative Humidity
＜
70%
a) Make sure the product is properly grounded before use.
b) The laser output head is connected with fiber optic cable. Please inspect the output head
carefully for dust or other contaminations. Use appropriate lens paper to clean it if necessary.
c) Failure to follow the instructions when operating the laser may cause malfunction and damage.
d) It is not allowed to install the output head when the laser is in operation.
e) Do not look into the output head directly. Wear appropriate protective eye glasses all the time
when operating the laser.
Tips: Install the laser in an air-conditioned environment for longer life and better performance.
2.5. Attentions
a) Make sure that the correct voltage of 380VAC is used. Connecting failure of power supply
will damage the device.
b) The output laser is collimated by the collimating lens, it is important to keep the collimating
lens clean, otherwise it will damage the device.
