Wuhan Raycus Fiber Laser Technologies Co., Ltd.
User Guide of RFL-C15000TZ
21
④
-FIBER WATER IN
⑤
-FIBER WATER OUT
⑥
- WATER OUT
⑦
- WATER IN
⑧
-Filter
①
-INTERFACE:
This interface provides all control signals, including: RS232 communication,
laser on/off control, laser remote control mode selection, analog control, modulation signal, Interlock
interface, etc.Refer to Table 4 for the definition of control lines. This socket comes with a protective
cover and a lock. When you are not using the product, you can cover the power input socket with the
protective cover and lock it with the lock.
②
-BREAKER:
The circuit breaker (air switch) on the rear panel of the laser is the main power
switch of the laser.
③
-AC INPUT:
The power input socket must be matched with the plug provided by us. This socket
comes with a protective cover and a lock. When you are not using the product, you can cover the power
input socket with the protective cover and lock it with the lock.
④
-FIBER WATER IN:
Output optical cable water inlet interface, this interface is connected to the
water outlet of the normal temperature water of the water cooler, and connected to the φ13 inner diameter
water pipe.
⑤
-FIBER WATER OUT:
Output optical cable water outlet, this interface is connected to the output
optical cable water inlet, connected to the φ13 inner diameter water pipe.
⑥
- WATER OUT:
The water outlet of the laser, this interface is connected to the cooling water
return port of the water chiller, and connected to the φ38 inner diameter water pipe.
⑦
- WATER IN:
The water inlet of the laser, this interface is connected to the water outlet of the
cooling water of the water chiller, and connected to the φ38 inner diameter water pipe.
⑧
-FILTER:
Filter the cooling water entering the laser.
4.3. Power connection
CAUTION:
(1) Before connecting to the AC power supply, please check whether the supplied AC
power supply meets the requirements in Table 1;
(2) Incorrect wiring will cause damage to the laser, so please check whether the power
cord is connected correctly before powering on the laser.
Figure 14 Shown is the power cord provided by the company.
