RaycoWylie i4500, Instruction Manual

Page: 82 / 91

55M4500EBE00A-A
82
i4500 Lattice Boom Crane
Instruction Manual
The i4500 system can support up to 4 generic interfaces. Each one can support a
wind speed sensor, an inclination level sensor and an absolute rotation encoder .
Activation of every generic card is done in the calibration menu section ‘‘ Enable/
Disable I/O’ ’.
D) Generic Interface Errors
Error message Execution process cause of Error
Lost communication with
generic card x
The i4500 system does not
receive data from generic
interface. If “ time out ” delay is
reached, then a communication
error is displayed
1) The generic interface is
broken
2) The cable that links the
interface to the canbus network
is defective.
cant x on generic x Waiting for a valid value of the
Cant X from the interface
1) The X axis of the
inclinometer is not calibrated
2) A wire between the cable
that links the interface to the
canbus network is cut.
cant Y on generic x
Waiting for a valid value of the
Cant Y from the interface
1) The generic interface is
broken.
2) A wire between the cable
that links the interface to the
canbus network is cut.
AIN 1 on generic x Waiting for a valid value of the
AIN 1 input from the interface
1) The AIN 1 input of the
generic interface is not
calibrated
2) A wire is cut between the
sensor connected to AIN 1
input and the interface
AIN 2 on generic x
Waiting for a valid value of the
AIN 2 input from the interface
The AIN 2 input of the
generic interface is not
calibrated
2) A wire is cut between the
sensor connected to AIN 2
input and the interface
Absolute rotation encoder Waiting for a valid signal from
the absolute interface
Absolute encoder is defective.
Rotation encoder’s 0 ref The proximity switch has been
detected when encoder did not
receive a pulse
Rotation encoder is defective.
Generic dr +
The
5
volts reference voltage
is
not
valid (if < 4.5 volts or >
5.5 volts).
The generic card is
defective