Ravenheat Energycatcher, Safety Instructions & Symbols Manual

Page: 13 / 22

Supplied By www.heating spares.co Tel. 0161 620 6677
13
Section
7 ENERGYCATCHER FIXING
7.1
Before fi tting remove the front cover of
Energycatcher by removing the 2 screws located on
the top of the front panel.
7.2
Slide up the front panel to dislocate it from fi xing
studs and remove.
Fig. 8.
Fig. 9
Fig. 8
7.3
IMPORTANT
Make sure the black rubber 60 mm
seal is located into the boiler top fl ue
exhaust manifold.
7.4
Before offering Energycatcher up to
the boiler it is important to lubricate
the inlet and outlet manifold on
Energycatcher and boiler.
IMPORTANT
Generally speaking oils and greases
are not suitable for the “peroxide-
EPDM“, therefore we suggest a correct
lubrication using silicone-substances,
for instance “ silikon spray” (Arexons)
or similar product.
7.5
Taking Energycatcher, lift it up on the top of the
boiler while at the same time ensuring that the 2
fl exible pipes ( condensing outlet pipe and drain
down braided hose) drop down the backframe
so that they can be connected later. Lift
Energycatcher onto the 2 fi xing bolts at the
upper top of the stand off backframe while
at the same time locating the Energycatcher
fl ue inlet manifold into the boiler black rubber
washer.
7.6
Tighten Energycatcher fi xing bolts.
Fig. 10
7.7
Fit desired fl ue as set out in main boiler installation
manual.
Note : If the fl ue from Energycatcher is
vertical then the fl ue connection must
start with a header sampling point. Part.
no. PR5094110A.
Fig. 10.
7.8
Flue resistance.
It is important to deduct appropriate fl ue length to
allow for Energycatcher’s increased fl ue resistance.
Details of which are set out in
section 3
.