Raven SmarTrax Case IH Steiger 335, Installation Manual

Page: 26 / 36

Chapter 4
22 Case IH Steiger & New Holland TJ/T90X0 SmarTrax™ Installation Manual
Install the Chassis Cable - SmarTrax-Only
Systems (If Applicable)
If the machine does not contain an existing chassis power system (such as AutoBoom, product control, etc.), it
is necessary to install the chassis power cable to operate the SmarTrax system. If a CAN system already exists
on the machine, refer to
Connect SmarTrax to an Existing Chassis Cable (If Applicable) below to connect the
power to the SmarTrax system.
Note:
The chassis cable is sold separately. Contact your local Raven dealer for ordering information.
1.
Locate the SmarTrax chassis cable (P/N 115-4001-085).
2.
Connect the TO SMARTRAX NODE connector from the chassis cable to the TO 115-4001-085 SMARTRAX
NODE CONNECTION connector on the node harness (P/N 115-4001-126).
3.
Connect the TO CONSOLE CABLE connector to the node harness.
4.
Connect the remaining connector on the node harness to the Raven console cable.
5.
Install a terminator (P/N 063-0172-369) on the CAN cable connector.
6.
Loop and tie-off the REMOTE SWITCH cable connection, securing it with plastic cable ties as necessary.
Note:
The REMOTE SWITCH connector is not used in the SmarTrax system. Ensure the cable is
secured away from moving parts and heat sources.
7.
Connect the ring terminals to the battery.
Note:
The positive connectors are fused.
Connect SmarTrax to an Existing Chassis
Cable (If Applicable)
1.
Locate and disconnect the connection between the Raven console cable and chassis cable on the
machine’s existing CAN system.
2.
Install the SmarTrax node harness (P/N 115-4001-126) between the chassis and Raven console harness.
3.
Loop and tie-off the TO 115-4001-085 SMARTRAX NODE CONNECTION ONLY cable connection,
securing it with plastic cable ties as necessary.
Note:
The TO 115-4001-085 SMARTRAX NODE CONNECTION ONLY connector is not used in systems
containing existing chassis cables.