Raven SmarTrax Case IH Steiger 335, Installation Manual

Page: 19 / 36

Manual No. 016-5032-004 15
Hydraulic System Installation
FIGURE 11.
Hoses Installed on Flow Switch
6.
Install the supplied 24” hydraulic hose on the pressure port of the steering valve.
Note:
Two 24” hydraulic hoses were included in the installation kit - one (214-1000-775) for smaller
models and another (214-1000-779) for larger models. Only one hose properly connects to the
pressure port. The other hose will not be used and may be discarded.
7.
Connect the other end of the installed hydraulic hose to one of the fittings on the flow switch.
8.
Install the supplied 13” hydraulic hose (214-1000-776) on the remaining fitting on the flow switch.
9.
Connect the other end of the installed 13” hydraulic hose to the machine’s pressure hose that was
previously disconnected from the steering valve.
Note:
For smaller models, connect the other end of the installed 13” hydraulic hose to the machine’s
hose that was disconnected from the back side of the bulkhead.
10.
Verify the hydraulic connections are tight.
11.
Start the machine’s engine and ensure the hydraulic connections are not leaking and hoses are not rubbing
on or interfering with other moving parts.
12.
Turn the wheels fully from side to side several times to purge air from the hydraulic system.
WARNING
Do not use hands to check for leaks in the
hydraulic system. Hydraulic fluid under
pressure can penetrate the skin and cause
serious injury or death.
Hose 214-1000-776
Connected to Previously
Disconnected Pressure
Hose
Hose 214-1000-775 or 214-
1000-779 Connected to PS
Port on Steering Valve
Front of Machine