![background image](http://html.mh-extra.com/html/raven/rgl-600/rgl-600_operation-manual_789029028.webp)
23
THE SMARTBAR CONFIGURATION MODE
(continued)
GPS
GPS Settings
Press SELECT button to set GPS Settings (GPS) to GEN (generic not used) or INV
(Auto configure Raven Invicta Receiver). The default setting is GEN (Generic). When
SYS-GPS is set to INV, and MENU button is pressed ‘INV-SEL-TO-INI.’ will appear.
Pressing the SELECT button will automatically set up the port of the invicta receiver
that the RGL 600 is connected.
BAUD rate will be set at 19200, GGA-ON at 10HZ, VTG-ON at 10HZ.
DSP - Display Settings
GPS
Optional DGPS Status Configuration format
Press SELECT button to set DSP-GPS to NRM or ADV (Normal or Advanced).
When DSP-GPS is set to NRM, the DGPS Status configuration main menu will display
six configuration sub-menus: GPS, D3X, HDP, AOD, SOG, and COG.
When DSP-GPS is set to ADV, the DGPS Status configuration main menu will display
four configuration sub-menus: GPS...D3x combined, HDP...AOD combined, SOG...COG
combined, and LAT...LON combined. This advanced setting allows monitoring of two
GPS status elements together and adds a Latitude and Longitude display. The ad-
vanced GPS display uses alternating display elements to show more data.
GUI
Guidance Display
Press SELECT button to set DSP-GUI to NRM or OVR (Normal or Overlay).
The default DSP-GUI setting is NRM. Swath offset error distance is shown in the right
hand Smartbar alphanumeric display. If the offset error distance display uses less
than two digits, a General Direction to Target Indicator digit is shown in the third
digit. This indicator points toward the guidance target. See the section “General
Direction to Target Indicator”. As the offset error exceeds two digits, the third digit is
no longer available to display the General Direction to Target Indicator. When DSP-
GUI is set to NRM, the General Direction to Target Indicator is not displayed when
the offset error is greater than two digits. When DSP-GUI is set to OVR, the General
Direction to Target Indicator is displayed alternately with the three-digit swath offset
error. (i.e. it is overlayed)
OFF
Offset Error display direction
Press SELECT button to set DSP-OFF to NRM or REV (Normal or Reverse).
The swath offset guidance Red LED bars normally light up pointing in the direction you
need to steer. This is the DSP-OFF default setting (NRM). To display the Red LED
bars in the opposite direction (the bar appears as if pointing toward the machine from
the swath line), set DSP-OFF to REV (Reverse). When DSP-OFF is set to REV, the
direction of the angle error indicator LED bars are also reversed.
Summary of Contents for RGL 600
