Raven AutoBoom, Installation Manual

Page: 66 / 92

Chapter 5
60 Miller Nitro 2000 Series AutoBoom™ Installation Manual
6.
Install the straight end of the supplied hydraulic hose (P/N 214-1000-301) on the installed fittings in the tank
port of the machine’s hydraulic valve.
7.
Connect the 45° end of the installed hydraulic hose to Port T on the AutoBoom valve.
Install the Pressure and Tank Hoses - Older Hydraulic Valves
FIGURE 5.
Pressure and Tank Hoses Installed on the Machine’s Hydraulic Valve
1.
Locate and disconnect the pressure hose from the right side of the machine’s hydraulic valve.
2.
If the machine’s pressure hose end is 11/16”, remove the fitting from the pressure port of the machine’s
hydraulic valve and install a 13/16” ORFS (M) to 3/4” SAE O-ring (M) straight adapter fitting (P/N 333-0012-
168) in the machine’s pressure port.
3.
Install a 13/16” ORFS M/M/F swivel run tee fitting (P/N 333-0012-028) in the pressure port of the machine’s
hydraulic valve.
WARNING
Hydraulics are under pressure. Care should
always be taken with a system that has been
pressurized. When disconnecting or purging
hydraulic hoses, be aware that the hydraulic
fluid within the machine’s system may be
extremely hot and under high pressure.
CAUTION
When installing AutoBoom hydraulics or
performing diagnostics, maintenance, or routine
service, ensure precautions are taken to
prevent any foreign material or contaminants
from being introduced into the machine’s
hydraulic system.
Objects or materials that are able to bypass the
machine’s hydraulic filtration system will reduce
performance and possibly cause damage to the
AutoBoom hydraulic valve.