Ravelli RBV 8008, Use And Maintenance Manual

Page: 136 / 293

Use and maintenance manual RBV 8008 - RBV 8010
Pag.39
Rev.1 18/05/2021
A A
B B
C C
D D
E E
F F
4
4
3
3
2
2
1
1
DISEG.
VERIF.
APPR.
FABB.
Qual.
SE NON SPECIFICATO:
QUOTE IN MILLIMETRI
FINITURA SUPERFICIE:
TOLLERANZE:
LINEARE:
ANGOLARE:
FINITURA: INTERRUZIONE
BORDI NETTI
NOME FIRMA DATA
MATERIALE:
NON SCALARE DISEGNO
REVISIONE
TITOLO:
N. DISEGNO
SCALA:1:20 FOGLIO 1 DI 1
A4
PESO:
50013DR00
AL 06 PELLETS FINISHED
- The pellet tank is empty. - Check for the presence of pellets in the
container. Top up, if necessary.
- The gear motor is not loading pellets - Empty the tank to see if there are any objects
inside that may prevent the proper operation of
the auger.
- Not enough pellets loaded - Regulate pellets setting from “SET AIR/
PELLETS”
- If the problem persists, contact the Support
Service Support
AL 07 RESET THERMAL BREAKER / PELLET
DOOR OR GATE OPEN
- The manual reset thermostat has tripped
connected to the hopper (RESET THERMAL
BREAKER /
Pellet door or gate is open
- Reset the thermostat by pressing the button on
the back of the stove or close the doors.
- Combustion in the grate is not optimal due
to the fact that the grate is clogged or the inner stove
ducts are clogged. (RESET THERMAL BREAKER)
- Switch off the stove, clean the brazier and the
tube bundle and adjust the combustion setting
the Pellet/Air values
- Contact the Support Service
AL 08 DEPRESSURIZATION
- The flue is blocked. Check the flue is free and clean
- The vacuum meter is faulty. - Contact the Support Service
AL 12 FUME EXHAUST SYSTEM
FAILURE
- T he fume exhaust system has a loss of
performance due to fan obstruction or voltage drop.
- Contact the Support Service
AL 14 SCREW PHASE
- No cable connection to power the gear motor
of the auger
- Contact the Support Service
AL 15 AUGER TRIAC
- An internal part of the electronic board that controls
the pellet infeed screw is faulty.
- Contact the Support Service
- Possible voltage drops or incorrect input voltage
stove inlet
- Check the mains voltage.
AL 17 NO FLOW
(only if the RDS system is provided)
- The flow meter does not measure inlet air flow - Check if the ash pan and door are
closed correctly and check if the air inlet pipe is
obstructed .
- If the problem persists, contact the Support
Service
Positions of the switch
protected by a screw cap and
of the reset safety thermostat
located on the
side.