9
RAVEAN
HEAT
™
C6 SYSTEM : 12V QUICK SINGLE BUTTON SETUP GUIDE
CHECK BATTERY POWER
Before using your heated product, make sure your
battery is fully charged. To do this, push the power level
button on your battery. When the battery is fully charged,
all four LED lights on the LED Power Indicator will light up
(see battery manual for charging unstructions).
1
CONNECTING BATTERY
Once your Ravean 12V battery is fully charged, plug
the 12v power cord into the 12v output port. Then
place it in the battery pocket.
2
1. CONTROLLER BUTTONS
2. 12V OUTPUT POWER PORT
NOTE: CONTROLLER BUTTONS ARE
INSIDE THE LEFT JACKET PANEL
3. 12V POWER CORD
4. BATTERY POCKET
JACKET QUICK START
Press and hold the controller buttons until the LED
light located on the button lights up. Once the LED
light is on, your garment will immediately begin
warming you.
3
1
4
1. CONTROLLER BUTTONS
TURNING ON JACKET: Press and hold any of the controller buttons for 1-2
seconds to turn on. The button will light up and pulse red as it preheats
(about 5 minutes). Then it will automatically adjust to medium heat
(white led light).
HIGH HEAT (RED LED): To place your jacket on high heat, press button once
after it turns on. The light will go solid red.
MEDIUM (WHITE LED): To place your heated jacket on medium heat, press
button twice after it turns on. The light will go solid white.
LOW HEAT (BLUE LED): To place your heated jacket on low heat, press the
control button three times after it turns on. The light will go solid blue.
NOTE: You can cycle through the various heat settings by continuing to
press the button.
TURNING OFF JACKET: To turn off, press and hold at any
temperature setting until LED light turns off.
12V OUTLET PORT
LED POWER INDICATOR
POWER LEVEL BUTTON
12.6V INLET PORT
USB OUTLET PORT
2
1
For full manuals go to ravean.com/manuals
1
3
