Rave Sports Super Shuttle 02964, Owner'S Manual, Page: 18 / 20

17
Cleaning and Storage
▪ When the Super Shuttle is not being used, store it in a covered, shaded area. This will help
protect it against ultraviolet (UV) rays and extend the life of the product. Do not allow the
Shuttle to sit in hot sun on the beach for prolonged periods. Air pressure within the Shuttle
could increase to levels which could cause damage or unrepairable rupture of the product.
Release air periodically to maintain proper and safe air pressure.
▪ Clean the Shuttle completely with mild soap and fresh water. NEVER USE PETROLEUM
BASED PRODUCTS OR SOLVENTS FOR CLEANING.
▪
Never use a power washer to clean the Shuttle. The high pressure spray will permanently
damage the soft PVC material beyond repair, thus voiding the warranty.
▪ Shuttle should be completely dry and remain dry while in storage.
▪ Roll the product loosely and place in a ventilated container, preferably one that rodents can’t
chew through.
▪
Secure the product to prevent unauthorized or unsupervised use.
▪
Store in a cool, dry location. Do not store product directly on concrete surface. Place
mothballs around stored inflatable to keep mice and insects away.
Repairs
For large holes, tears or seam damage, contact RAVE Sports Customer Service at 1-800-659-0790.
IMPORTANT: repair glue is not included with this product. Repair glue and additional patch material
is available from RAVE Sports.
For minor holes or tears:
▪
Inflate the product properly and locate the leak by spraying the tube with mild soapy water.
▪
Determine the hole size and cut a patch 1-2 (3-5cm) inches wider than the diameter of the
hole. Make sure all corners of the patch are rounded.
▪
Deflate product and clean the patch and area around the hole with rubbing alcohol. Let dry.
▪
READ AND UNDERSTAND THE WARNINGS ON THE GLUE CONTAINER.
▪
Apply glue to patch and the area around the hole. Let the glue dry until it is tacky to the touch.
▪
Lay the product on a flat, hard surface and apply the patch. Working from the center to the
outer edge, rub out any air bubbles between the patch and the product.
▪
Let the patch dry for 24 hours before attempting to inflate the product.