Ravanson XPB-680TP, User Manual

Page: 16 / 54

16
3. Close the inner lid of the spin drying chamber and the transparent outer lid
ATTENTION!
The spin dryer will not start when the outer (transparent) lid is open!
4. Using the spin drying timer knob (4) - see FIG. III page 5 CONTROL PANEL select the required spin
drying time (1 to 5 minutes)
5. The spin dryer starts work based on the selected spin drying parameter
6. After the cycle is finished, the spin drying timer knob goes to 0 position automatically.
ATTENTION!
The spin dryer has a brake activated when the outer lid is open. It is not recommended to open the outer lid
of the spin dryer when running. When it is necessary to open the lid, the brake will activate and spin drying
will be stopped.
When the spin dryer fails to stop, discontinue the cycle and contact the maintenance service.
Do not use the spin dryer with a damaged braking system!
WARNING!
Wait until the spin dryer stops entirely. Do not insert hands into the spin dryer chamber when running!
The suggested spin drying time for various textiles:

Shirts - 1-2 minutes

Bedclothes- 3-5 minutes

Work clothes - 5 minutes
V. RINSING
1. Rinsing can be carried out in the washing chamber. Repeat the washing programme three times:
Washing - spin drying/ Washing - spin drying/ Washing - spin drying.
Add the laundry conditioner to the last, third washing cycle. After the rinsing and water drainage cycle has
finished, put the laundry to the spin dryer and carry out the last spin drying cycle.
Rinsing can be carried out directly after water has been drained from the washing chamber or after the first
spin drying which is recommended for improved washing effect.
2. Rinsing can be carried out in the spin drying chamber. The spin dryer has a dedicated water inlet (5) -
see FIG. III p. 5 CONTROL PANEL.
To the water inlet opening (5), to the right of the control panel for the washing machine / spin dryer, connect
the appropriate supply hose end (2), having raised the opening plug. Connect the other hose end to the tap -
see FIG. VII page 6. It is recommended to fix it to the tap by means of a clamp (the fixing system is not included
in the washing machine / spin dryer set).
After the first spin drying ends, the laundry in the spin dryer chamber can be filled with clean water
and then spin dried. Repeat that a couple of times.
VI. AFTER THE WASHING MACHINE / SPIN DRYER CYCLE IS FINISHED
1. Disconnect the plug
2. Disconnect the supply hose from the washing machine / spin dryer and water supply (tap)
3. Hang the drain hose up
4. Remove any dirt and fibres from the washing machine and spin dryer chambers, wipe dry
and open all lids to let the residual water evaporate
5. Clean the filter
VII. FILTER CLEANING
– see FIG. VI page 6
The washing machine / spin dryer is equipped with a circulation water filter placed in the washing chamber.
The dirt and fibres settle on the filter mesh. Clean the filter after each washing cycle.
To remove the filter, pull it forwards with high force. The filter should be cleaned carefully under running water,
dried and replaced.