Rauch AXIS-M 30.2, Instruction Manual

Page: 50 / 148

Commissioning 7
42
7.2 Requirements for the tractor
To ensure a safe and correct use of the machine of the AXIS series, the tractor
must meet the necessary mechanical, hydraulic, and electrical requirements.

Universal drive shaft connection: 1 3/8 inches, 6 splines, 540rpm,

Oil supply: max. 200 bar, single or double-acting valve (depending on equip-
ment)

Operating voltage: 12 V,

Three-point linkage, category II
7.3 Mounting the universal drive shaft at the machine
Depending on the version, the machine may be equipped with different universal
drive shafts:

Transmission with radial pin clutch,

Tele-Space transmission with radial pin clutch.

Check the mounting position.
-
The drive shaft end that is marked with a tractor symbol must point to the
tractor.
n
CAUTION
Material damages due to unsuitable drive shaft
The machine is delivered with a drive shaft that is designed according
to the device and performance.
The use of incorrectly dimensioned or inadmissible drive shafts, for
instance without guard or suspension chain, may cause personal
injury or lead to damage to the tractor and/or the machine.
 Use universal drive shafts approved by the manufacturer only.
 Follow the directions in the operator’s manual of the universal
drive shaft manufacturer.
1. Remove the protective cap.
2. Loosen the locking screw [1]
of the universal drive shaft
guard.
3. Turn the universal drive
shaft guard to the demount-
ing position.
4. Pull the universal drive shaft
out.
Figure 7.1: Loosen the universal drive
shaft guard
1