Rauch AXIS H EMC Series, Instruction Manual

Page: 87 / 132

Spreading operation
81
8
Mounting the spreading discs
Requirements:

PTO and tractor engine are switched off and locked to prevent unauthorised
starting.
Mount the left spreading disc on the left side in the direction of travel and the right
spreading disc on the right side in the direction of travel. Make sure that the left
and right spreading discs are not reversed.
The following procedure is for mounting the left-hand spreading disc. The right-
hand spreading disc is to be mounted according to these instructions as well.
1. Put the left spreading disc onto the left spreading disc hub.
The spreading disc must be evenly placed on the hub (if required, remove
dirt).
2. Carefully position the cap nut (do not tilt).
3. Tighten the cap nut with approx. 38 Nm.
4. Check that there is clearance between the spreader vanes and the outlet by
turning the spreading discs by hand.
3. Unscrew the cap nut.
4. Remove the spreading disc
from the hub.
5. Put the adjustment lever
back into the designated
bracket.
Figure 8.4: Unscrew the cap nut
NOTICE
The pins on the spreading disc holders have different positions on the left and
right side. The correct spreading disc is the one that fits precisely into the
spreading disc holder.
NOTICE
The cap nuts have an internal catching mechanism that prevents them from
coming loose. The catching mechanism must be noticeable while tightening,
otherwise, the cap nut is worn and must be replaced.