Commissioning
41
6
Definition of mounting height
The information on the mounting height refers to the distance between the lower
edge of the spreading disc and the ground with a horizontally mounted machine.
The mounting height (dimension
A
) is
55 cm
.
Measure the distance between the lower edge of the frame and the ground.
-
A clearance of
33 cm
is required (dimension
B
).
Figure 6.7:
Setting the mounting height
[A] = 55 cm
[B] = 33 cm
1.
Start the tractor.
The PTO shaft is switched off.
2.
Move the tractor to the machine.
Do not latch the lower link hooks into place yet.
Make sure there is enough space between the tractor and the machine in
order to be able to connect the drives and control elements.
3.
Switch off the tractor engine. Remove the ignition key.
4.
Pull the hand brake of the tractor.
5.
Mount the drive shaft to the tractor.
6.
Connect the electrical and hydraulic metering slide actuators and the lightning.
NOTICE
Maximum mounting height
In order to prevent accidental contact with the spreading disc, the distance be-
tween the lower edge of the frame and the ground must not exceed
120 cm
(di-
mension
B
).
This corresponds to a maximum admissible mounting height of the machine of
142 cm
(dimension
A
).
B
A
Summary of Contents for AXEO 16.1
