Machine settings
7
62
3.
Reset the spreading vanes against the rotary direction of the spreading disc.
With this setting, the spreading material is ejected earlier.
4.
Screw on the spreading vane (tightening torque: approx. 18 Nm).
Always
use new self-locking
nuts when screwing on the vane.
The spreading density on the right-hand side viewed in the direction of
travel is increased.
7.8.2
Increasing the spreading density on the left-hand side in the direction of travel
1.
Observe the rotational direction of the spreading discs. Refer to
2.
Disassemble the screws of the spreading vanes including the corresponding
nuts and washers.
Figure 7.12:
Spreading density on the left in the direction of travel
White arrow: Rotational direction of the spreading disc
Grey arrow: Adjustment of the spreading vanes in the rotational direction of the
spreader disc
3.
Set the spreading vanes in the rotary direction of the spreading disc.
Using this setting, the spreading material will be ejected
later
.
4.
Screw on the spreading vane (tightening torque: approx. 18 Nm).
Always
use new self-locking
nuts when screwing on the vane.
The spreading density on the left-hand side viewed in the direction of
travel is increased.
Summary of Contents for AXEO 16.1
