Appendix
43
● Silicon rectifier
Check the conduction performance between the two
terminals.
It is normal in case of conduction in forward direction and
non-conduction in the reverse direction.
● Reset switch
With the switch in the "ON" state, confirm the conduction
performance between the two terminals.
3-4-8 Starter motor
1)
Disassembly and assembly
When disassembling the starter motor, please follow the above steps to disassemble the starting control box
first.
Installation:
⚫
During installation, the opening
faces the electromagnetic switch
side.
⚫
Tighten the wires of the oil level
switch and the fuel cut-off
solenoid valve.
Harness clip
Control box
fixing bracket
(model with
control box)
Installation:
⚫
As shown in the figure, connect
the starter cable at an angle of
30° to the horizontal line.
⚫
Make sure that the starter cable
will not interfere with the starter
motor.
Starter motor
Wire clip
Installation:
When installed, the opening
faces upwards.
Electromagneti
c switch
terminal
Terminal
nut
10×12mm
locating pin
（
2
）
Starter
