Part IV Wiring Diagram
19
Connect one detection wire to the wire end of the
spark plug cap, make the other detection wire
contact with the spark plug end, and then measure
the resistance of the spark plug cap.
Resistance value
10KΩ
②
Clearance
1.
Unscrew the ignition coil bolt.
2.
Insert a plug gauge between the ignition coil
and the flywheel, and adjust the ignition coil
position.
3.
After adjustment, pre-tighten the bolt, check
the clearance again, and then tighten the bolt
and apply the torque if the clearance is
correct.
Clearance
0.4±0.05mm
4)
Charging coil
Connect the two ends of the multimeter to the two
connectors of the charging coil, and measure the
resistance of the charging coil.
Resistance value
3A
20A
0.6Ω
Spark plug cap
Ignition coil
Fly
whe
el
