Ratek SWB10D Water Bath - Operating Manual
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Page 15 of 24
required set-point once the cradle is carrying enough momentum to maintain the lower speed.
Stopping the Oscillating Cradle
Stopping the Oscillating Cradle
Stopping the Oscillating Cradle
Stopping the Oscillating Cradle
-
Slowly turn the Oscillation speed control knob (element 2 in Figure 1) anti-clockwise down to setting
0.
-
Turn power Off to the oscillating cradle by setting the Oscillation On/Off mains power switch (element
6 in Figure 1) up to the setting marked with a circle. The Oscillation On/Off mains power switch
(element 6 in Figure 1) will go dark which indicates the speed control is now inactive.
Switching Off The Water Heating
Switching Off The Water Heating
Switching Off The Water Heating
Switching Off The Water Heating
-
Switch the Heating On/Off mains power switch (element 8 in Figure 1) up to the position marked with
a circle. The Heating On/Off mains power switch (element 8 in Figure 1) will darken which indicates
the heating system is now inactive.
CAUTION
CAUTION
CAUTION
CAUTION
Although the heating system may now be inactive, the residual heat in the heating element may be
sufficient to cause serious burns or scalding.
The residual water temperature may also be sufficient to cause burns or scalding.
Allow at least 10 minutes after switching off the heating system to allow the heating element to cool.
Allow the water temperature to reach ambient room temperature before proceeding to empty the water
tank.
Emptying The Water Tank
Emptying The Water Tank
Emptying The Water Tank
Emptying The Water Tank
CAUTION
CAUTION
CAUTION
CAUTION
Do not empty the water tank while the water is hot as burns or scalding may result.
-
Turn off both mains power switches (elements 6 and 8 in Figure 1) by setting these to the up position
marked with a circle.
-
Unplug the equipment from the mains power supply outlet.
-
Remove all containers, racks and accessories from the water tank and place them in a safe place, do
do
do
do
not remove the oscillating crad
not remove the oscillating crad
not remove the oscillating crad
not remove the oscillating cradle
le
le
le.
-
Allow the water bath water to cool down until it reaches ambient room temperature.
-
If emptying the water into another container, ensure the container is place below the level of the water
bath on a firm, hard, flat surface.
-
If emptying into a sink or drain, ensure you have clear and unobstructed access to it.
-
Ask for assistance to empty the water tank. Depending on the volume of water in the tank, you may
require 2 people to lift the water bath. The water bath should be lifted in accordance with any local
operational health and safety guidelines in place.
-
The water must be emptied towards the end of the water bath furthest from the control panel. This
reduces the volume of water that may come into contact with the control panel. This end is indicated
by the following caution label on the case of the water bath.
