EN
If the blade is no more able to cut (even after repeating
the sharpening operation several times) it is necessary to
replace it. In order to carry out this operation, use butterfly
key “1” and drift “2” locking the blade (shown in picture
11). In order to replace the blade, proceed as follows:
1) Use some protective gloves in compliance with the
Local Law of the Country where the machine is to
be used (use of personal protection devices);
2) Remove safety protection “B”, by unscrewing the
two slotted screws “A” by means of a screwdriver
(not supplied by the manufacturer), as shown in picture
12.
3) Insert drift “2” in hole “C” in order to lock the blade
(the hole in the blade must correspond to the hole
in the structure) (see picture 13).
4) Use butterfly key “1” in order to unscrew nut “D”
(see picture 13) and remove blade “E” (see picture 14).
5) Replace the worn blade with the new one “3”, being
careful to center the blade on the gear, in the correct
position, and remember to assemble it with its sharp
side (the one with the writing Rasor) positioned
towards the external side of the pneumatic scissors.
6) Assemble all the components again and carry out
some cutting and sharpening tests.
1
3
2
11
13. LUBRICATION
Every 3-4 working days, it is necessary to lubricate the
gear pair. In order to carry out this operation, remove
protective plug “A” located on the head of the pneumatic
scissors and fill it with the grease supplied. Screw plug
“A” again a few turns. Screw plug “A” a few turns every 2-
3 working days (see picture 10) when the machine is
used without interruption.
WARNING
The blade must never be dirty with grease or oil.
14. BLADE REPLACEMENT
10
A
12
A
B
A
13
C
D
E
2
1
14
27
Enfocus Software - Customer Support
