9
Introduction for buttons on remote controller
Note:
● When selecting auto mode, air conditioner will operate automatically according
to ex-factory setting. Set temperature can’t be adjusted and will not be displayed
as well. Press "
F
AN" button can adjust fan speed. Press " " button can
adjust fan blowing angle.
● After selecting cool mode, air conditioner will operate under cool mode. Cool
indicator " "on indoor unit is ON. Press "▲" or " " button to adjust set tempe-
rature. Press "
F
AN" button to adjust fan speed. Press " " button to adjust
fan blowing angle.
● When selecting dry mode, the air conditioner operates at low speed under dry
mode. Dry indicator " " on indoor unit is ON. Under dry mode, fan speed can’t
be adjusted. Press " " button to adjust fan blowing angle.
● When selecting fan mode, the air conditioner will only blow fan, no cooling and
no heating. All indicators are OF
F
. Press "
F
AN" button to adjust fan speed. Press
" " button to adjust fan blowing angle.
● After putting through the power, the air conditioner will give out a sound.
Operation indic
a
tor " " is ON (red indicator). After that, you can operate the air
conditioner by using remote controller.
● Under on status, pressing the button on the remote controller, the signal icon " "
on the display of remote controller will blink once and the air conditioner will give
out a “d
i
” sound, which means the signal has been sent to the air conditioner.
ON/OFF button
MODE button
▲
1
2
Press this button can turn on or turn off the air conditioner. After turning on the air
conditioner, operation indicator " " on indoor unit’s display is ON (green indicator.
The colour is different for different models), and indoor unit will give out a sound.
Press this button to select your required operation mode.
AU
T
O COOL
FAN
D
RY
HE
AT
(Only applicable to heat pump model)
● This is a general use remote controller, it could be used for the air conditioners
with multifunction;
Specific functions are not applicable to this model
,
I
f press the
corresponding button on the remote controller
,
the unit will keep the original
running status.
