31
2.
As shown in Pic.1, put the appliance on the water bucket vertically.
ATTENTION! Pay attention if the overflow outlets are blocked by foreign objects, which may
lead to overflow. Keep the overflow outlets unblocked when use.
3.
Put the appliance in inclined level as shown in Pic.2, and hold the handle firmly. Start the
operation by pressing <Power> button. The pads will be cleaned by rotation. Suggested to clean
the pads for 10-20 seconds.
ATTENTION! Do not press the extension poles heavily, otherwise, safety protection will be
activated and stop the operation.
4. After cleaning, switch off the appliance by pressing <Power> button once. Step on the drainage
foot pedal repeatedly to discharge the sewage into the waste water tank.
5. After several time of drainage, certain sewage accumulated inside the waste water tank.
Pour them out by holding the handle of the water bucket as shown in Pic.3.
6.5
Change of battery in handle
To operate and use the water spray function, you should install battery on the handle. Follow the
below steps to install:
1.
Take out the battery cover on the handle with a screwdriver.
2.
Insert two AAA batteries as indicated.
3.
Close the battery cover and tighten the screw with a screwdriver.
ATTENTION! Identify the positive and negative poles when install the batteries.
ATTENTION! During installation, take good care of small accessories to avoid losing them.
ATTENTION! If there is no operation or water spray after batteries installed, follow the steps above to
re-install or replace the batteries.
