32
6.6
Nozzle cleaning
Press and hold the <Water spray> button about 5-10 seconds to access the water spray function. Water
will be sprayed steadily such to keep the nozzle head unblocked. If not, follow the instructions below
to clean the nozzle,
Rotate the nozzle head counter-clockwise to detach.
As shown in Pic.2, block the inner part of the nozzle slightly by fingers. Press the <Water spray>
button repeatedly to start water spraying. There will be water overflows between the inner part and
your fingers. Repeat several times to discharge the blockage.
After clearing, turn the nozzle head clockwise to put it back.
ATTNTION! Pay extra attention when install the small inner part. If the inner part is lost, the water
spraying function may not work properly.
ATTNTION! When you hang the appliance to clean the walls, the water spray function will be disabled.
7.
Charging
Be sure to fully charge the battery when used for the first time or when not used for a long time.
(
DO NOT
operate the appliance when charging)
WARNING!
The electricity supply must be 220V AC, and the adapter supplied must be used. It may
cause malfunction or fire if improper adapter is used to charge the appliance.
Turn on the main switch to ON position, otherwise, the appliance cannot be charged.
Insert the connector of the adapter into the charging jack of the mopping head, and the adapter
head to the power socket
When charging, the
indicator on the mopping head will be in red. The indicator will be switched
off when charging is completed.
