11
Rasha Professional A/S | 1800 Rustin Ave, Riverside, CA, 92507 | 951-654-3585
Rashaprofessional.com | [email protected]
Attention
Start Addresses
After switching on, the device will automatically detect whether DMX 512 data is received or
not. If there is data received at the DMX input, the DMX LED next to the LCD display will flash.
If no DMX signal data is received? This situation can occur if:
−
the XLR plug (cable with DMX signal from controller) is not connected with the input of
the device.
−
the controller is switched off or defective, if the cable or connector is defective or the
signal wires are swap in the input connector.
To set the device to work with a DMX controller
* Press MODE until <DMX Address> is displayed and press ENTER.
* Use <UP> and <DOWN> to set the DMX start address and press ENTER.
Use the table below to define the correct address. The table shows the settings for units 1 to
3. Apply the same principle for the other units. Example:
Channel Mode
First Unit
Second Unit
Third Unit
Highest Start address
8
Start Address
1
9(1+8)
17(9+8)
505
