5
Rasha Professional A/S | 1800 Rustin Ave, Riverside, CA, 92507 | 951-654-3585
Rashaprofessional.com | [email protected]
4.2 Setup
AC Power
The pixel controller has an auto-ranging power supply and it can work with an input voltage
range of 100 to 240 VAC, 50/60 Hz. To determine the
product’s
power requirements (circuit
breaker, power outlet, and wiring), use the current value listed on the label affixed to the
product’s
back panel, or refer to the
product’s
specifications chart. The listed current rating
indicates the
product’s
average current draw under normal conditions.
▪
Always connect the product to a protected circuit (circuit breaker or fuse).
Make sure the product has an appropriate electrical ground to avoid the risk
of electrocution or fire.
▪
To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the product from power via breaker or by
unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch
Fuse Replacement
▪
Wedge the tip of a screwdriver into the slot of the fuse holder.
▪
Pry the fuse holder out of the housing.
▪
Remove the blown fuse from the holder and replace with a fuse of the exact same type
and rating.
▪
Insert the fuse holder back in place and reconnect power
Installed fuse
(held by plastic clip)
Disconnect the product from the power outlet before replacing the fuse.