QUICK START GUIDE
en-12
START UP SCREEN
When the Ignition Key is turned to the on
position, this screen is shown.
The Hour Meter will show total hours of
engine operation.
WARNING/SERVICE SCREEN
After the start up screen, the warning screen
is shown.
If the machine is within 5 hours of the next
service interval, a warning is shown. An
operator input is needed to continue to the
main screen for operation. Otherwise the
main Home Screen appears. If a fault
condition has occurred during the previous
start, a pop up screen over the top of the
warning screen shows the fault. The
operator must confirm the fault to continue to
the main screen.
HOME SCREEN
This screen shows the Cutter Switch in the
OFF position, the TST™ is in operation and
the Park Brake is applied.
NOTE: The TST™ (Tilt Sensor Technology)
is an optional active safety device to warn
you when the machine is being used in
unsuitable conditions.
If TST™ is installed, it is disabled while the
machine is in Transport mode and the TST™
icon will be crossed through.
If TST™ is not installed the TST™ icon will
be crossed through.
Ransomes Jacobsen recommends that the
owner/user of the machine completes a site
specific risk assessment of the area to be
mown prior to operation of the machine.
2.5 Hours
®
WARNING
If incorrectly used this machine can cause
severe injury. Those who use and maintain
this machine should be trained in its proper
use, warned of its dangers and should
read the entire operators manual before
attempting to set up, operate,
adjust or service
the machine.
1234
123.4 Hours
P
TM
®
VISUAL DISPLAY
