Ransomes 51 Super Certes, Safety, Operation & Maintenance Manual

Page: 44 / 128

en-44
9 ACCESSORIES
9.1 BRUSH AND COMB SET______________________________________________
A brush and comb set are available for this range of
machines. Do not use the brush in wet conditions.
1. Remove the bolt [A] on both sides of the front roll.
2. Fit the bracket [B] and tighten the bolt [A].
3. Loosen the nuts [C] at each end of the brush or
comb.
4. Put the turned studs [C] into the slot brackets.
5. Tighten the nuts on [C].
NOTE: Check the washers engage with the nuts.
The brush or comb is adjustable, on a vertical axis, to the grass condition. Always make sure that the unit is level
before you tighten the nuts.
If the bristles of the brush, through continuous use, wear at an angle, reverse the brush unit in its frame.
NOTE: The brush or comb bracket [B] can stay fitted to the machine.
9.2 TRANSPORT WHEELS (SUPER CERTES ONLY)__________________________
These wheels are driven by a coupling on the rear roll spin-
dle.
Wheel fitting and Removal.
1. Lift the rear roll away from the ground with
the kickstand.
2. Hold the quick release clip [A] down.
3. Fit or remove the wheels as required.
B
C
A
A