Ransburg Vector AA90 79580, Service Manual

Page: 64 / 88

AH-07-01.8
Vector AA90 Applicators - Maintenance
5 9 5 9 5 9 5 9 5 9
Spray T Spray T
Spray T Spray T Spray Tip Removal/Carbide
ip Removal/Carbide
ip Removal/Carbide ip Removal/Carbide ip Removal/Carbide
Removal Removal Removal Removal Removal
1. Remove the retaining nut completely by hand.
2. Remove the air cap from applicator using the
tool provided. Gently slip the tool blades
underneath the two cut-outs on the air cap, pushing
forward.
Figure 42a: Spray Tip Removal/Carbide Figure 42a: Spray Tip Removal/Carbide
Figure 42a: Spray Tip Removal/Carbide Figure 42a: Spray Tip Removal/Carbide
Figure 42a: Spray Tip Removal/Carbide
Removal Removal
Removal Removal
Removal
Figure 42b: Spray Tip and Seal Removal Figure 42b: Spray Tip and Seal Removal
Figure 42b: Spray Tip and Seal Removal Figure 42b: Spray Tip and Seal Removal Figure 42b: Spray Tip and Seal Removal
Figure 42c: Spray Tip Removal/Carbide Figure 42c: Spray Tip Removal/Carbide
Figure 42c: Spray Tip Removal/Carbide Figure 42c: Spray Tip Removal/Carbide Figure 42c: Spray Tip Removal/Carbide
Installation Installation
Installation Installation Installation
Barrel Removal Barrel Removal
Barrel Removal Barrel Removal
Barrel Removal
1. Remove air cap and retaining ring.
2. With a flatblade screwdriver, remove trigger
screws and trigger.
3. Loosen the fluid tube barrel connection.
4. Using 19749 special wrench, remove barrel
nut.
5. Hold applicator handle, pull barrel straight out.
With Cascade units, the entire cascade assembly
will be removed. With Classic units, the resistor
tube housing will be left in the applicator handle.
3. Push the spray tip and holder out of the air cap
by pressing with a finger or soft object on the
carbide or tapered portion of spray tip. The carbide
spray tip contains a removable nozzle seal with or
without a pre-orifice. The pre-orifice seal is black,
the standard seal is white. To remove the sealfrom
the tip holder, hold the end of the tip and the end of
the seal and snap apart the two pieces.
4. By hand push the seal into the tip holder as
shown. The seal will be held in place in the holder.
Then place the tip holder on the insertion tool. Hold
the tip upright, align the pin in the cap to the slot in
the tip holder and push together. The tip should
snap in place in the air cap.