AH-07-01.8
Vector AA90 Applicators - Installation
3 3
3 3
3 3
3 3
3 3
Figure 15: I/O Cable Stripping
Figure 15: I/O Cable Stripping
Figure 15: I/O Cable Stripping
Figure 15: I/O Cable Stripping
Figure 15: I/O Cable Stripping
Figure 14: Cable Grommet
Figure 14: Cable Grommet
Figure 14: Cable Grommet
Figure 14: Cable Grommet
Figure 14: Cable Grommet
AC INPUT
AC INPUT
AC INPUT
AC INPUT
AC INPUT
CONNECTIONS
CONNECTIONS
CONNECTIONS
CONNECTIONS
CONNECTIONS
(((((CLASSIC UNITS
CLASSIC UNITS
CLASSIC UNITS
CLASSIC UNITS
CLASSIC UNITS)))))
For non-conduit installations, plug the detachable
AC line cord into the receptacle on the side of the
power supply. Plug the other end of the line cord
into a properly grounded 120 volt AC outlet.
For installations where it is required to run the AC
input wiring in conduit, perform the following:
1. Ensure the AC line cord is unplugged
Ensure the AC line cord is unplugged
Ensure the AC line cord is unplugged
Ensure the AC line cord is unplugged
Ensure the AC line cord is unplugged and
remove the AC inlet receptacle wiring from TB1-N,
TB1- L1 and TB1-EARTH GROUND (see Figures
16a and 16b).
2. Remove the mounting hardware from the AC
inlet receptacle and remove it from the rear of the
control unit.
3. Install the Conduit Adapter Plate (supplied) in
the hole where the AC inlet receptacle was
removed (see Figure 16c).
>
Due to variations in source connec-
tions, European units are shipped without
an AC line cord. When selecting a line cord
for these units, select one that has the ap-
propriate source connector at the plug end,
and an IEC-60320 C13 connector at the
power supply end of the cord. The cord
should be rated for at least 60
°
C, have
0.8mm
2
(18 AWG) minimum conductors
and be less than 6m (20 feet) in length.
N O T E
N O T E
N O T E
N O T E
N O T E
>
In general, conduit must be used for ap-
proved AC installation, however, if national
and local codes permit, the AC power may
be supplied via the factory supplied line
cord. If conduit is utilized, the power supply
AC input wiring may be routed through an
optional explosion proof switch mounted on
or near the spray booth where it will be con-
venient to the operator.
N O T E
N O T E
N O T E
N O T E
N O T E
Summary of Contents for Vector AA90 79580
Page 19: ...AH 07 01 8 Vector AA90 Applicators Introduction 14 14 14 14 14 NOTES NOTES NOTES NOTES NOTES...
Page 43: ...AH 07 01 8 Vector AA90 Applicators Installation 38 38 38 38 38 NOTES NOTES NOTES NOTES NOTES...
Page 73: ...AH 07 01 8 Vector AA90 Applicators Maintenance 68 68 68 68 68 NOTES NOTES NOTES NOTES NOTES...
