09/11/2018
RANS S-21 OUTBOUND
TEXT MANUAL
125
13.
Route the Flap Teleflex Cable inside the Fuselage. Route both Flap Teleflex
Cables aft of Station 3 down the side of the fuselage and forward through the
wire loops welded to the fuselage frame at Station 2A. Both Teleflex Cables route
forward and connect to the Flap Handle. Secure Teleflex cables mid-way up on
Station 3 with Cushion Clamps.
14.
For adjustment of the Flaps, refer to
RIGGING
.
15.
Fabricate the Fuel Lines to connect the Wing Fuel System to the Fuselage Fuel
System. Refer to
FUEL SYSTEM INSTALLATION - FUSELAGE
.
NOTE:
Fuselage section of the fuels system is dependent on engine
selection.
16.
Refer to
FIGURE 06I-19.
Position the Wing Root Bottom Gap Seal on the bottom
side of the Wing so that the flange is tight against the Fuselage frame. Mark and
drill #30. Remove gap Seal. Drill Wing Bottom Skin to #11. Install Tinnermans on
Bottom Wing Skin.
17.
During final assembly, at
tach the 1/2” Black Foam Tape to the flange that will rest
against the fuselage frame. Attach the gap seal to the wing with the screws
provided.
18.
Installation of Flap Gap Seal will be done after
WINDSHIELD INSTALLATION
.
NOTE:
The Flap Gap Seal is installed to the top forward skin on the
tailcone and closes the gap between Fuselage and Flap.
19.
Connect Pitot line to Union Elbow connector in the wing.
