09/11/2018
RANS S-21 OUTBOUND
TEXT MANUAL
111
SEAT BELT INSTALLATION - (FINISHING KIT)
(AFTER PRIMING OF FUSELAGE FRAME/ BEFORE SKINNING)
1.
Prior to covering drill the welded attach bushings to 5/16". Refer to the PARTS
MANUAL DRAWING for attach bushing locations.
(AFTER SKINNING AND PAINTING OF FUSELAGE)
2.
After the fuselage has been covered and painted, bolt each Seat Belt to the
respective attach bushing as shown in the PARTS MANUAL DRAWING.
3.
Use the elastic bands on the lap belts and lower shoulder belts to hold the tail of
the belts after adjustment has been made.
4.
This seat belt design allows for quick exit out of both lap and shoulder belts
simply by opening the buckle. To use, simply pull belts over lap and shoulder and
adjust.
NOTE:
To exit, un-clip lap belt.
IMPORTANT:
The shoulder belt must pass over the
OUTSIDE
shoulder
(in either seat) then diagonally across the chest to the lap belt attach point.
Always make sure that seat belts are properly positioned and snug prior to
and during entire flight.
CAUTION
:
FOR SOLO FLIGHT -
SECURE UNUSED SEAT BELT
