Rankam GR2297801-MM-00, Assembly & Operating Instructions

Page: 47 / 51

47 of 51 20181220-Ver.1.0
PROPERLY INSTALL THE BURNER
Firmly seat the valve orifice into the burner tube. Make sure the valve orifice is inserted
STRAIGHTLY
into the burner tube.
Burner flames will be yellow, with excessive noise, lifting or flash back if the burner is not
installed properly.
THE PELLET CONTROL PANEL REPLACEMENT
1. Disassemble the bolts on the hopper bottom panel.
2. Cut off the cable tie for internal wires.
3. Disconnect all the wire couplings of fan motor, auger drive motor, hot rod and power cord
(Detail wire pairing is as shown in P.48 DIGTAL THERMOSTAT CONTROL WIRING
DIAGRAM).
4. Disassemble the bolts on the pellet control panel then take out the control panel from the
bracket.
5. Hold up the pellet control panel and disassemble the bolts for fixing the terminals of
temperature detector (RTD sensor) then you can remove the terminals of temperature
detector.
6. Replace a new pellet control panel. Connect all the wire couplings to the related position
(refer P.48 DIGTAL THERMOSTAT CONTROL WIRING DIAGRAM). Tie up the wires with
cable tip then assemble all the parts with their original bolts.